DVR User Manual
30
Step1: Enter into Menu
Setup
Alarm
Motion tab. Refer to Fig 4-23:
Step2: Enable motion alarm, set alarm hold time which refers to the time till
which the system will wait for further detection of motion. Eg. If the holding
time is set to 10 seconds, once the system detects a motion, it will go into
alarm but would not detect any other motion alarm (specific to channel) until
30 seconds. If there is other motion detected during this period, it is
considered it as continuous movement, otherwise it will be considered as a
single motion.
Step3: The setup steps of motion trigger are similar to „Alarm Handling‟. You
can refer to Chapter 4.5.1 Sensor
Alarm Handling for more details.
Step4: Click “Setting” button under the Area to display the following
picture as shown in Fig 4-24: Fig 4-24 Motion-Area
Step5: In the Area tab, you can drag slide bar to set the sensitivity value (1-8). The higher the value is the more sensitive it is to
motion. Since the sensitivity is influenced by color and time (day or night), you can adjust its value according to the practical
conditions. Left click the grid and drag to delete area. Drag again to add area. Click
icon to set the whole area as detection
area. Click
icon to clear the set detection area. Click
icon to
test the sensitivity as per the local
conditions. Once motion is sensed, it
displays a figure icon. Click
icon to save the setting. Click
icon
to exit the current interface.
Note
: Prior to setting motion detection field it is recommended that
you click
icon to clear the existing field and set afresh.
Step6: Select “All” to setup all channels with the same parameters.
Step7: Click “Apply” button to save the setting.
Step8: Enter into Schedule tab. The setup steps for schedule for motion
based alarm are similar to normal schedule setup; you can refer to
4.4.1 Schedule for details. Fig 4-25 Motion-Schedule
This step is very important for motion based alarm. Even if you have enabled the motion based alarm for all channels and setup
Page 36 of 109
