Appendix C: Specifications and Characteristics
ON Series m UPS User Instruction Manual
21
Appendix C: Specifications and Characteristics
Table 7. Physical/Electrical Specifications
and Performance Characteristics*
Specification and Characteristics
ONm300J ONm600J
ONm300I
ONm600I
ONm300A
ONm600A
Maximum Load - VA/Watts
300/200 600/400
300/200 600/400
300/200 600/400
Load Power Factor Range
UPS .65 to 1.0 (3) - will support loads rated 0.5 to 1.0
Crest Factor
<3
Nominal Input Voltage
120 VAC
230 VAC
120 VAC
Low Limit for On-line Operation
@ 50% Load
87 VAC
183 VAC
87 VAC
High Limit for On-line Operation
@ 50% Load
138 VAC
266 VAC
138 VAC
Unit Start-up Range
93-138VAC
190-266 VAC
93-138 VAC
Frequency Limits (on-line)
50/60 Hz +/- 5%
Input Connection
IEC 320 (M) inlet
Input Over Current Protection
resettable, linked dual pole (L & N) breaker
Boost Voltage
approximately 10% boost to output voltage when input voltage falls below 80%
of nominal
Output Voltage on Backup
@ 50% Load
110 VAC ± 10%
220 VAC ±10%
110 VAC ± 10%
On Battery Waveshape
amplitude stabilized stepped sine-wave
On Battery Frequency
50/60 Hz +/- 1%
Transfer Time
4mS, typ
Output Connection
(4) IEC 320 (F) connectors
(2/4) 5-15R
Battery Type
maintenance free, spill proof, sealed lead-acid
Typical Battery Life
3-6 years, depending on number of discharges and ambient temperature
Recharge Time (60% Recovery)
6-10 hours
Communications
isolated basic signaling
Interface Connector
25 pin male sub D style
Output Signals
on battery (pin10) / low battery (pin 1)
(TRUE condition causes “short” to RETURN signal (pin 11))
Input Signal
inverter shut down [pin 20 (+) to pin 21 (-)]
(high shuts down inverter)
Maximum Collector Voltage (VDC)
15
Maximum Collector Current (mADC)
10
Maximum Output Voltage @ 5
mADC
0.8
