Installation
8
ON Series m UPS User Instruction Manual
1. Disconnect the input power cord(s) from the
device(s) the UPS will be protecting.
NOTE:
One of the disconnected power cords will be
used as the input power cord for the UPS.
2. Use IEC 320 (M/F) cord(s) to connect the
device(s) to the UPS IEC 320 (F) output
connectors.
Contact ONEAC Technical Support if your
equipment does not have a detachable IEC 320
power cord.
UPS to Power Source
To connect the UPS to the AC power source, use the
input power cord supplied with the device to be
protected.
Connect the UPS to the AC utility power source as
shown in figure fig. 6.
fig. 6: Connecting Load(s) to UPS and Connecting UPS to AC Power Source
Utility
Power
Device #3 to
be Protected
ONm UPS
Device #1 to
be Protected
Device #2 to
be Protected
Input power cord disconnected from protected device
IEC320 M/F power cord, (1) provided