Installation
Sinergy S II Series Series UPS User Instruction Manual
7
Rack-Mounting the
UPS or External
Battery Cabinets
The UPSs and external battery are designed to be rack-mounted in four-post frames. The UPS and external
battery cabinets use identical mounting hardware and the procedure for mounting either is the same.
NOTE:
The Rack-mount UPS draws cooling air from the front. If the rack has a door on the front, make
sure that there is some clearance between the vents and the rack door.
Because of the weight of these units, two people are recommended to lift and hold into position while all
fasteners are secured. Please use only the supplied fasteners to attach the supplied mounting brackets to
the UPS or external battery.
If external batteries are included in your installation, please mount them first and as low as possible. Start
with the lowest available position and work up. Your UPS should be installed last and end up on the top
of all the battery units for proper cable routing.
ATTENTION:
Use all supplied mounting hardware on each UPS and external battery. NEVER depend
on lower devices to support other devices.
All mounting materials are provided to install the UPS into a rack. To prepare the UPS and external
batteries for use in a rack configuration, first install the included mounting rails, then install the UPS and
batteries following the steps below.
1. Assemble side rails and secure each rail together with three screws.
2. Attach front of rails to front of rack with two screws provided.
3. Attach rear of rails to rear of rack with two screws provided.
4. Attach front brackets to each side of UPS with four screws on each side.
5. Slide UPS into position in the rack and secure with two screws on each side of UPS.
6. Repeat the above steps for each UPS or battery to be mounted.
Fig. 2: Mounting the UPS in a Rack
After mechanical installation is complete, follow the instructions in “Connections” on page 9. Connect
your UPS and external battery cabinets.
Summary of Contents for S07KXAU
Page 3: ......
