Functioning
Lift sensor
There are lift sensors located on each front wheel. If the mower was lifted 2cm from the
ground in level way, the blade stop working within 2s, but the wheels keep running. And
the blades start cutting within 5s after two front wheels get back to ground.
Tilt sensor
There is tilt sensor installed on the mower too, when the mower was tilted over 30 degree
at any direction, it also will stop working within 2 seconds.
Bump sensors
In front of the mower there equipped with bump sensors that will activate when the
mower strikes solid, fixed object when that object is at least 6.5cm in vertical height from
the supporting surface of the mower. When the bump sensor is activated, the mower will
stop movement in that direction and reverse itself away from the obstacle.
Rain sensors
There are two rain sensors on top cover of mower. The mower will go back to the charging
station automatically when it's raining.
Wireless controller
To control the operate of mower in manual pattern.
Anti-theft function
The mower should be turned on by key. And it can’t start working without
a matched charging station.
Virtual wire
The robot lawn mower can't operate without a virtual wire. (we suggest to
use 100m-300m of virtual wire). It leads the mower back to charging
station and the mower will take it as a wall when it is operating. It will gets
on the virtual wire until it meets charging sheet which located in front of
charging station, then it gets off virtual wire and starts cutting.
Cutting height selection
There are two choices, 3cm and 4cm.
32
Summary of Contents for 10011554
Page 1: ...Rasenmähroboter 10011554 10011555 10011556 ...
Page 5: ...Lieferumfang 5 ...
Page 29: ...Product Overview 29 ...
Page 53: ...Contenu de la livraison 53 ...
