16
Initial Operation
•
Insert two AAA batteries into the remote sensor and three AA batteries into the weather
station.
•
Wait 3 minutes or until the outdoor temperature is displayed in the weather station. Do not
press any keys before outdoor sensor data received.
•
Every time the remote sensor is powered up (for example after a change of batteries), a
random security code is transmitted and this code must be synchronized with the base
station to receive weather data. Thus if battery change happened on transmitter side, then
the receiver must be power up again to re-learn the transmitter.
After the remote sensor is powered up, the sensor will transmit weather data every 8s for 6
times. After this learning period is over, then the transmitter will transmit every 48s.
•
When the base station is powered up, a short beep will sound and all LCD segments will
light up for about 3 seconds before it enters into learning mode to learn the sensors security
code.
Note:
DO NOT PRESS ANY KEY during the first 3 minutes learning period. After both indoor and
outdoor data are displayed you can place your remote sensor outdoors and set your time. If
there is no temperature reading in the indoor station, make sure the units are within range of
each other or repeat the battery installation procedure. If a key is pressed before the weather
station receives the temperature signal, you will need to follow the battery installation proce-
dure again. Please wait 10seconds before re-insert the battery again to make a proper reset for
both transmitter and receiver.
Mounting
•
Base station
With one foldable legs at the back of the unit, the base station can be placed onto any flat
surface or wall mounted at the desired location by the hanging holes also at the back of
the unit. It is important to check that the radio signal can be received before permanently
mounting any of the units
•
Remote sensor
Note: To achieve a true temperature rea-
ding, avoid mounting remote sensor in direct
sunlight. We recommend that you mount the
remote sensor on an outside North-facing
wall; obstacles such as walls, concrete, and
large metal objects will reduce the range.
To wall mount, use 3 screws to affix the wall
bracket to the desired wall, plug in the remo-
te sensor to the bracket.
Summary of Contents for 10029960
