Operation
1. Connect to power source
(siehe
Putting into Operation
).
2. Switch on
:
Press the ON/OFF switch.
Setting the casting distance
Short
: Pressing the ON/OFF switch once sets the short casting distance. The bottom
lamp lights up.
Middle
: Pressing the ON/OFF switch twice sets the middle casting distance. The
middle lamp lights up.
Wide
: Pressing the ON/OFF switch a third time sets the middle casting distance. All
three lamps are lit.
3. Insert balls
Insert one or several balls into the machine.Insert one or several balls into the
machine. The balls will be shot out after a short time.
In case there already balls in the machine
Gently shake the
machine and move
the balls towards
the end of the exit
chute.
Place the machine
on the ground and
turn the power on.
Tilt the machine
slightly upwards so
that the exit chute
points at an upward
angle. Then press
and hold the power
button for 5 seconds
to start up the
machine.
Once the machine
turn on power put
it back onto the
ground or tilt the
exit chute so that
it is at a downward
angle, to allow the
ball to shoot out
from the machine.
13
