XII. Fan / Blower Wiring Diagram
-
Baldor Motors
Wiring should always be done by a licensed electrician!
*** All motors should be grounded.
2HP Cyclonic Wood Dust Collector Owners Manual
O.A.S. 2005
c
Before Operation
- Before making electrical power connections, check for proper grounding of motor and
application. All electrical contacts and connections must be properly insulated and enclosed. Coupling, belts,
chains or other mounted devices must be in proper alignment, balance and secure to insure safe motor
operation.
Electrical Wiring
- Prior to connecting to the power line, check motorplate for proper voltage and rotation
connection. This motor should be installed in compliance with the National Electrical Code and any other
applicable codes. Voltage at motor not to or - 10% of nameplate voltage. Licensed electrician should
make all electrical connections.
Inlet
Outlet
Outlet can be rotated and
oriented independent of inlet.
Counter-clockwise
if looking down
from the top.
Always use the wire diagram on the motor plate. Sometimes the wire diagrams on the motor will be for
different rotation. Wire for counter-clockwise rotation.
13
Ground: Connect house ground
wire to green chassis screw in
motor wire housing box.
Motor
Wire
Box
Green
Chassis
Screw
***
2hp Fan / Blower Wire Diagram - Single & Three Phase
Connect leads 1, 2, 3 to power line(s) L1, L2 & L3.
To reverse rotation interchange any two power line leads.
Three Phase
Low Voltage
208 - 230v
L1
L2
L3
1 & 7
2 & 8
3 & 9
4
5
6
Connect
Three Phase
High Voltage
460V
L1
L2
L3
1
2
3
7
8
9
4
5
6
1, 8
4
Single Phase
Low Voltage
115V
Line 1
Line 2
(Neutral)
2
J
5
Single Phase
High Voltage
208 - 230V
4
Line 1
2
3
5
J
Tape
Wire Nut
Tape &
Insulate
1, 3, 8
Wire Nut
Tape &
Insulate
Line 2
