Oneida Air Systems 2005c3HP, Owner'S Manual

O.A.S. 2005

c

3HP High Vacuum Owner’s Manual

Cyclone

Barrel

Cyclone

Cone

2.

3.

2. Clamp the fan housing and cyclone barrel to

the cyclone cone with the clamp ring. Note: the

fan / blower and the cyclone barrel are very

heavy. The system will be top heavy. One method

is to lay the stand down, then bolt the cyclone

with the fan / blower to the stand. The iron ring

will slide into stand.

3. Tip the fan housing and cone upright. The

system is very top heavy.

4. Bolt the elbow-cartridge housing to the fan

housing outlet (rectangular). Clamp the cartridge

to the flat plate. Clamp the dust bins to the

bottom of the cartridge filters.

Continued on next page.

7

Pleated

Cartridge

Filters

(Do not remove

fabric straps

from cartridge.)

Removable

Dust

Container

5hp Integral

Fan Blower

Angle Iron

Stand

Outlet

Inlet

Elbow

Square-to-Round

Cone

Cyclone

Clamp

Ring

VI.  Assembly Instructions

Cyclone

Barrel

Air Inlet

Fan / Blower

1.

1. Orient the blower housing to match the stand

configuration and the desired angle for the cyclone inlet.

Bolt the fan / blower to the cyclone barrel using the

hardware taped on the motor.

Bolts are already welded on Fan/Blower unit. Put strip

of the neoprene gasket around the cyclone barrel behind

the bolt holes. Then put bolts through holes in barrel.

Put flat washer on bolt. then lock washer, then hex nut.

Cyclone Inlet and Fan / Blower are independent.

Filters can be to the right or left of the unit.

Air

Outlet

Neoprene

Gasket

Material

16 ea. 3/8” Flat Washers, Lock Washers and Hex Nuts

Fan / Blower is shipped strapped to Cyclone Barrel. It is

NOT attached to the unit. You must bolt them together.

Follow the instructions below.

One bolt hole

on each side.

Do NOT use

hook on motor

to lift unit.