17
oneida-air.com
Assembly Instructions (Continued)
To ground the filter, attach the ring terminal
on the braided ground wire from the Motor
Assembly (A) to a bolt on the filter plate, under
the nut, then attach the alligator clip to the
filter’s cage [FIG. 15].
Note:
If you need to extend the wire, you can use
any 16 gauge copper stranded wire and connect
with wire nuts
17
To ground the drum, attach the 14” Grounding
Cable (K7), start a small hole in bottom of cone
(D) above the Flex Hose (F) and on the top of
the dust drum’s Lid (G), then attach the wire
with the included 3/8” Self-tapping Screws
(K10).
Note:
If you need to extend the wire, you can use
any 16 gauge copper stranded wire and connect
with wire nuts
18
To install the Dust Sentry (P) refer to the
included instruction sheet:
• Dust Sentry Sheet
#ZBI000002A
19
FIG. 14
FIG. 15
Summary of Contents for Dust Gorilla Pro
Page 2: ......
Page 25: ...23 oneida air com Notes ...
