10
2hp 50hz Super Gorilla Owner’s Manual © O.A.S. 2010
VIII. Filter Assembly
External 99 cm Filter Assembly
*Silencer Included
5. Attach fi lter cartridge with provided J hooks making sure
the gasket is sealed tightly and internal silencer is in fi lter.
7. Attach the fi lter dust bin to the bottom of the fi lter with
the J hooks making sure that the seal is tight.
1. Attach gasket to collector outlet making sure there are
no gaps where gasket ends meet.
2. Attach Plenum to outler using the included 7 bolts and
hardware making sure the support hanger on the Plenum
is at the bottom.
3. Attach gasket around cut out in fi lter plate as shown
in diagram, making sure there are no gaps where ends
meet.
4. Attach fi lter plate to Plenum using the 9 included elevator
bolts, washers and nuts, putting them up through the plate
and Plenum from underneath making sure the shaped bolt
shaft is snug in the diamond hole in plate.
6. If fi lter requires additional support, use the plate at the
top of the fi lter to support the fi lter assembly or support
hanger on Plenum.
Note: If fi lter cartridge is located away from the cyclone
and motor, additional square to round connectors and
pipe can be purchased.
Filter
Mounting
Plate
Gasket
Plenum
Support
Hanger
J Hook
Gasket
Outlet
J Hook
2hp Filter Plate
Gasket
4 hole side is near
dust collector.
