background image

16

XIV. Terms and Conditions

  Please look over the shipped order very carefully in the presence of the delivery person for damage or 
incomplete shipment before signing the delivery receipt. Please note any tears or irregularities in shipping 
packaging, however slight, on the shipping delivery receipt. This could be an indication of extensive 
concealed damage. The shipping company will not take responsibility if the damage is not noted on the 
delivery receipt. In the event of shipping damage, call O.A.S. immediately so we can expedite 
replacements. Please check in all parts within 3 days from receiving order. Notify O.A.S. immediately of any 
missing or incorrect parts. O.A.S. does not accept any claims for damage or shortage after 3 days from 
date of delivery.

Checking in Order

Limited Warranty

*Note: Motors should be protected from extreme weather to prolong motor life.
Single phase motors should only be started and stopped up to 4 - 10 times per
hour. Starting single phase motors more frequently can cause heat build up
and can cause the motor overload to trip or cause motor damage. In general,
motors should be started and stopped as little as possible for maximum
lifespan and best economy (electrical use).

  Products will be shipped to Buyer’s single destination. Title and risk of loss shall pass to the Buyer upon 
delivery to such destination. Buyer pays transportation expenses. Dates of shipment are advisory and 
O.A.S. will make reasonable efforts to ship on or before the date states for shipment, however, O.A.S. shall 
not incur any liability for failure to ship on that date.

Delivery Risk of Loss

Returned Goods Policy

Installing a dust collection system will greatly reduce airborne dust levels in your shop. However, NIOSH recommends 

that respirators must be worn if the ambient concentration of wood dust exceeds the prescribed exposure limit. If in  

doubt wear a NIOSH mask.

Oneida Air Systems warrants products it manufactures for a period of 2 years to the original purchaser from the date of 

purchase. Items not manufactured by O.A.S. are limited to their own manufacturer’s warranties. All electrical items such as 

magnetic starters, remotes, sensors, pumps and sccessories are limited to 90 days. This warranty does not apply to defects 

directly or indirectly to misuse, negligence, accidents, abuse, repairs, or alterations or lack of maintenance. This is Oneida 

Air Systems sole written warranty and any warranties that may be implied by law, including any merchantability or fi tness, 

for any particular purpose, are hereby limited to the duration of this written warranty. O.A.S. does not warrant or represent 

that the merchandise complies with the provisions of any law or acts unless the manufacturer so warrants. In no event shall 

O.A.S.’s liability under this warranty exceed the purchase price paid for the product and any legal actions brought against 

Oneida Air Systems shall be tried in the State of New York, County of Onondaga.

Oneida Air Systems shall in no event be liable for death, injuries to persons or property or for incidental, contingent, special, 

or consequential damages arising from the use of our product.

Oneida Air Systems does not warrant or authorize use of wood dust collectors for other purposes. This includes wood prod-

ucts that are treated, coated, or otherwise altered from their natural state.

Buyer must inform O.A.S. of any shortage or damage, by so noting in writing, on the freight delivery bill prior to signing to 

indicate receipt of shipment. All claims, including claims covered under the limited warranty, are subject to inspection and 

investigation by O.A.S. O.A.S. reserves the right to inspect, investigate all returned products before Buyer’s claim is settled. 

All products returned for a cash refund must be unused, resaleable and purchased within 30 days. There are no refunds 

on fl ex hose, custom made components or partial kit items. Kits must be returned in full (all components) for credit. There 

will be a 25% restocking fee applied to any returned items. Buyer must call and get an RMA (Return Authorization 

Number). Merchandise must be shipped to us prepaid.

2hp 50hz Super Gorilla Owner’s Manual © O.A.S. 2010

Summary of Contents for Super Dust Gorilla






















Reviews: