Pulse
Bar
oneida-air.com
17
18
Install the Barrel Gasket (G2) onto the
rounded, bottom edge of the Motor Assembly
(A). The Barrel Gasket (G2) should be oriented
so that the "ribbed" side is facing downwards
[FIG. 18].
Assembly Instructions (Continued)
FIG. 19
G16
A
19
Attach one end of the Vinyl Tubing (G16)
onto the barbed fitting located underneath the
Motor Assembly's (A) plastic cowl. The fitting
will be on the side opposite to the pulse bar.
Push the hose onto the fitting so that all of
barbs are covered [FIG 19].
Note: The Motor Assembly's plastic cowling can
be temporarily removed for easier access to this
fitting during installation. Lift the foam placed
at the top of the cowl to access the retaining nut.
Replace the foam and the hardware when you
have finished attaching the Vinyl Tubing. Refer
to maintenance section as shown on page 22.
FIG. 18
G2
A
DO NOT TURN ON OR PLUG IN YOUR DUST COLLECTOR UNTIL INSTALLATION IS COMPLETED.
NEVER RUN THE SYSTEM WITHOUT THE MOTOR COWLING IN PLACE.
Summary of Contents for Supercell XSK000030
Page 2: ......
Page 33: ...31 oneida air com Notes...
