G18
M
oneida-air.com
19
23
Connect the Dust Sentry (J) to the smaller
power cord on the Motor Assembly's (A)
magnetic starter. The Dust Sentry (J) should
be mounted in a highly visible area using
adhesive strips or the Sentry's two mounting
holes [FIG. 23].
•
Refer to the
Dust Sentry Installation Sheet
for more information.
Note: The Dust Sentry's location is limited by
the two wires extending from the Strobe Light.
The Infrared Sensor must have sufficient length
to install in the pre-cut hole on the Steel Drum
Lid (K).
Assembly Instructions (Continued)
24
Install the Quick-Disconnect Kit (G17) onto
the bottom section of the Drum (L) [FIG. 24].
•
Refer to the
Quick Disconnect Installation
Sheet
for more information.
25
Place a Liner Bag (G18) inside the Drum (L).
Take care to ensure that the Liner Bag (G18) is
fully expanded to the inside of the drum and
so that the upper edge of the Liner Bag (G18)
is folded out and over the lip of the drum [FIG.
25].
Note: If you do not wish to use a liner bag you
must insert Round Tapered Plug (G17G) into
the Quick Disconnect Kit (G17) from inside the
Drum (L).
G17F
G17E
G17D
G17C
G17B
G17A
FIG. 23
FIG. 24
FIG. 25
A
J
G17G
Summary of Contents for Supercell XSK000030
Page 2: ......
Page 33: ...31 oneida air com Notes...
