V - Systems Owner’s Manual O.A.S. 2010
c
IV. Stand Assembly
Stand Kit Contents
Hardware Kit (1) - AHX002107
Rubber Leg Cap (3) - RCR012500
Rubber Leg Cap
Stand Leg
Stand
Brace
Mid-
Gusset
Top
Gusset
Mounting
Ring
Cone
Top Gusset (3) - RFG010000
Mid-Gusset (3) - RFG010003
Stand Leg Set 35 Gal. (3) - OSK354800
Stand Leg Set 55 Gal. (3) - OSK556200
1. Place rubber leg caps on long end of leg.
2. Attach top gusset and mid-gusset to legs using 2” carriage
bolts then a washer and Nylock nut.
3. Attach the braces to the mid-gussets using the 3/4” car-
riage bolts and a washer and Nylock nut.
4. Attach cyclone cone to top gussets using the mounting ring
by 5/16”x 1” bolts using the sequence of bolt, washer, cone/
stand, washer, Whiz nut.
Stand Braces
Note: Stand legs will angle slightly inward when connected to
cyclone. This adds stability to the unit and makes a slightly larger
footprint than if the legs were perfectly vertical.
