4
Getting Started incl. Installation
This OneRemote DAB/FM tuner has been designed for operation in a Bang & Olufsen
remote control system allowing full control with a Bang & Olufsen remote control
terminal either directly or via connection to Bang & Olufsen equipment.
Thus the tuner is Beolink compatible.
Direct Mode or CableLink Mode
The OneRemote DAB/FM tuner is always connected to Bang & Olufsen equipment with
the 7-pin DIN cable, but through option programming it may be controlled as follows:
1.
Via the tuner’s built in IR-receiver, ”Direct Mode”
Direct Mode is used when connection to an input with control data is not
possible.
2.
Via the cable connected Bang & Olufsen equipment, ”CableLink Mode”
CableLink Mode is used when connection to an input with control data is
possible.
See page 22 for
Option Programming.
Factory Settings
The factory setting is for “Direct Mode”.
The factory setting for input socket and selected source is:
•
Beo4 og Beo5
N.MUSIC, A.MEM2 or.TAPE2
•
Beolink 1000
SHIFT A.TAPE
If the DAB/FM tuner is connected to a
different
input, the option should be
programmed accordingly. See page 22 for
Option Programming
Installation
•
Select option and complete option programming, if required
•
Connect the tuner to the correct input socket
•
Connect power supply and antenna to the tuner
•
Select the source on the remote control terminal
By selecting the correct source on the Bang & Olufsen remote
control terminal, the DAB/FM tuner is automatically turned on.
