4
www.oneremote.dk
Getting Started
This OneRemote iRadio2 has been designed for operation in a Bang & Olufsen remote control system allowing full
control with a Bang & Olufsen remote control terminal either directly or via connection to Bang & Olufsen
equipment.
Thus the iRadio2 is BeoLink compatible.
Direct Mode or CableLink Mode
The OneRemote iRadio2 tuner is connected to Bang & Olufsen equipment via the 7-pin DIN cable with or without
adaptor, and through option programming it may be controlled as follows:
1.
Via the tuner’s built in IR-receiver, ”Direct Mode”
Direct Mode is used when connection to an input with control data is
not
possible.
2.
Via the cable connected Bang & Olufsen equipment, ”CableLink Mode”
CableLink Mode is used only when connection to an input with control data is possible.
See page 8 for
Option Programming.
Factory Settings
The factory setting is for “Direct Mode” and manual power control.
The factory setting for input socket and selected source is:
Remote control
Source
Beo4, Beo5 or Beo6
N.MUSIC, A.MEM2 or TAPE2
BeoLink 1000
SHIFT A.TAPE
If the iRadio2 tuner is connected to a
different
input, the option should be programmed accordingly.
See page 8 for
Option Programming
