ASSEMBLY INSTRUCTIONS (50-JN1301)
7 of 13
STEP 3
Screw six Minifix Bolts (C) into the corner holes of the Bottom Board (7) and insert the six Dowels (B) into the
middle holes.
STEP 4
Place six Cams (D) into the lower holes of the Left Board (4), Right Board (5), and Middle Board (6). Note the
arrow on the face of each Cam. It should be pointing toward the nearest edge of the board where the
Minifix Bolt (C) will go in.
Before attaching the Left, Right, and Middle Boards to the Bottom Board (7), make sure the unused Cam holes
are all positioned on the same side. Then, align the boards with the six Minifix Bolts (C) and six Dowels (B) and
push them down until tight. Tighten the six Cams (D) clockwise half a turn to lock the boards into place.
B x 6
D x 6
C x 6
4
6
7
7
5
The unused holes should be
on the same side.
CAUTION:
Do not overtighten
cams.
C
D
