© Copy Right One Touch Ltd, 1992-‐2014 – All Rights Reserved
John Mackay
Page 16
23/05/2014
Only MANAGERS may assign Fobs on the till, start by pressing a “Clerk” Key or
scanning your Fob. (Note: Fobs must be setup)
Touch
the
MANAGER
button and enter your pin (This is the pin you assigned
during setup of your Till), the word manager will appear in green at the top of
the screen to confirm management mode…
Touch
the
MANAGER
button
AGAIN
…
Touch
the
MANAGER
button
The Settings screen will now be
loaded,
Touch
the
Fob Setup
button.
The Fob Setup Screen will now be
loaded…
To Create a
New Fob
, Touch the
ID box then scan the fob, the fob
ID will automatically appear. Now
touch the
Down Arrow
to the
right of the Clerk Box and select
the desired clerk to assign the fob
too.
Note:
If the clerk is not listed
then return to till mode and press
the required clerk to create a clerk
profile.
Touch Save to apply.
To Edit an Existing Fob, touch the
FOB ID in the Fob list, (If you do
not know the FOB ID then touch
ID and scan the fob to view the
ID).
Change the clerk then touch save
to edit or touch Delete to remove the Fob from the system.
Assigning Fobs
