10
1300 886 649
Model: AAC-114 Product Code: 48463 12/2014
www.tempo.org
AUS
Waterproof housing
The camera comes supplied with a transparent waterproof housing, which
allows you to take video footage or photos in wet conditions, even in or under
water, up to a depth of 3 metres.
To use the camera with the waterproof housing, proceed as follows:
• Select the desired mode (photo or video).
• Select the desired menu options.
• Place the camera in the waterproof housing and close it carefully using the
locking clip located at the right side of
the case.
• Once the camera is securely installed,
you can use the ON/OFF and SHUTTER
buttons by pushing the push buttons
located on top of the waterproof
housing.
WARNING
:
Once the camera is installed in the case, make sure that all seals
are in place to prevent water intrusion.
Getting Started (Cont.)
Before using the camera in wet conditions
• Before sealing the case, ensure the camera housing’s rubber seal is clean
— a single hair or grain of sand can cause a leak. You can test by closing
the case without inserting the camera. Submerge the case completely
in water for about a minute. Remove the case from the water, dry off its
exterior with a towel, then open the case. If the entire interior is dry, the
case is safe for use under water.
• Remember to select which mode you would like to record in by using the
MODE switch before inserting the camera into the waterproof case. There
is no external button for the MODE switch.
• After every use in salt water, rinse the outside of the housing with non-salt
water and dry. Not doing this can eventually cause corrosion of the hinge
pin and salt build-up in the seal, which can cause failure.
•
WARNING
: Do not use aggressive substances such as acetone to clean
the case, which can cause permanent damage.
• To clean the seal, rinse in fresh water and shake dry (drying with a cloth
may cause lint to compromise the seal). Re-install the seal into the grooves
in the back door of the housing.
Locking
Clip
