5
Description remote control buttons
Protection
Troubleshooting
The device has a sophisticated protection circuit against the short circuits, distinguishing itself with the simultaneous
flashing of all LEDs for a few seconds, in this case must be unplugged the power cord and leave unplugged for at
least 15 minutes..
Symptom
Cause
Remedy
No power
supplied to unit
Incorrect operations are often mistaken for trouble and malfunctions. If you think that there is something wrong
with this component, check the points below. Sometimes the trouble may lie in another component. Investigate the
other components and electrical appliances being used. If the trouble cannot be rectified even after exercising the
checks listed below, ask your nearest ONIX authorized service center or your dealer to carry out repair work.
Power plug is disconnected from outlet
Check that power cord and insert the plug
securely into outlet
No sound
Connecting cords are disconnected
from terminals, or connected
incorrectly
Check if connections between CD-player and
the amplifier are connected correctly.
No sound from
one speaker
Connecting cords or speaker cords are
disconnected.
Verify that the cables between amplifier and
CD-player are well- connected according to
the different polarity.
The position of the input selector does
not correspond to the component to be
played back.
Check that the selector on the amplifier is
positioned on the input of the CD.
RANDOM button
: allows the random selection of tracks,
screen shall display “R”.
REPEAT button
: Press once to repeat a single track or twice to repeat the entire CD,
screen shall display
“T” o “A”.
A-B segment repeated play:
Press REPEAT key three times at the start point of your desired content. Screen shall
display A- in front of the track. Press REPEAT key again at the stop point of your desired content. Screen shall
display A-B in front of the track and the machine shall repeatedly play the segment between start point A and stop
point B until REPEAT key is pressed again to cancel segment play
.
FAST REWIND/FAST FORWARD
:
During normal playback, press button ( ) to search backward at high
speed,
release this key to return to normal playback. During normal playback, press ( ) button to search forward at high
speed, release this key to return to normal playback.
.
TRACK SELECTING:
Press numerical key 1 to 9 to select track
.
Press ( ) button on front panel or ( ) key on
remote control to play the previous track.Press ( ) button on front panel or ( ) key on remote control to play the
next track
.
DISPLAY BRIGHTNESS ADJUSTMENT:
Press (DIMMER) key on remote control to adjust the brightness of
displayed characters
,
each time (DIMMER) key is pressed, screen brightness shall change from “bright”, “normal”
to
“dark” in circular.
Screen will be set to “bright” as default when the machine is turned off.
MUTE buttom
: pressing (MUTE) button while the CD is plaing will activate the mute function (no sound), will,
display the message "MUTING" flashing, press the button (MUTE) for return to normal.
