Onkyo CS-265 Instruction Manual Download

Page: 5 / 256

En-

Precautions

1. Recording Copyright

—Unless it’s for personal

use only, recording copyrighted material is illegal
without the permission of the copyright holder.

2. AC Fuse

—The AC fuse inside the unit is not user-

serviceable. If you cannot turn on the unit, contact
your Onkyo dealer.

3. Care

—Occasionally you should dust the unit all

over with a soft cloth. For stubborn stains, use a soft
cloth dampened with a weak solution of mild
detergent and water. Dry the unit immediately
afterwards with a clean cloth. Don’t use abrasive
cloths, thinners, alcohol, or other chemical solvents,
because they may damage the finish or remove the
panel lettering.

4. Power

WARNING

BEFORE PLUGGING IN THE UNIT FOR THE
FIRST TIME, READ THE FOLLOWING
SECTION CAREFULLY.
AC outlet voltages vary from country to country.
Make sure that the voltage in your area meets the
voltage requirements printed on the unit’s rear
panel (e.g., AC 230 V, 50 Hz or AC 120 V, 60 Hz).

The power cord plug is used to disconnect this unit
from the AC power source. Make sure that the plug
is readily operable (easily accessible) at all times.

For models with [POWER] button, or with both
[POWER] and [ON/STANDBY] buttons:
Pressing the [POWER] button to select OFF mode
does not fully disconnect from the mains. If you do
not intend to use the unit for an extended period,
remove the power cord from the AC outlet.

For models with [ON/STANDBY] button only:
Pressing the [ON/STANDBY] button to select
Standby mode does not fully disconnect from the
mains. If you do not intend to use the unit for an
extended period, remove the power cord from the
AC outlet.

5. Preventing Hearing Loss

Caution

Excessive sound pressure from earphones and
headphones can cause hearing loss.

6. Batteries and Heat Exposure

Warning

Batteries (battery pack or batteries installed) shall
not be exposed to excessive heat as sunshine, fire or
the like.

7. Never Touch this Unit with Wet Hands

—Never

handle this unit or its power cord while your hands
are wet or damp. If water or any other liquid gets
inside this unit, have it checked by your Onkyo
dealer.

8. Handling Notes

• If you need to transport this unit, use the original

packaging to pack it how it was when you
originally bought it.

• Do not leave rubber or plastic items on this unit

for a long time, because they may leave marks on
the case.

• This unit’s top and rear panels may get warm after

prolonged use. This is normal.

• If you do not use this unit for a long time, it may

not work properly the next time you turn it on, so
be sure to use it occasionally.

• When you’ve finished using this unit, remove all

discs and turn off the power.

9. Installing this Unit

• Install this unit in a well-ventilated location.
• Ensure that there’s adequate ventilation all around

this unit, especially if it’s installed in an audio
rack. If the ventilation is inadequate, the unit may
overheat, leading to malfunction.

• Do not expose this unit to direct sunlight or heat

sources, because its internal temperature may
rise, shortening the life of the optical pickup.

• Avoid damp and dusty places, and places subject

to vibrations from loudspeakers. Never put the
unit on top of, or directly above a loudspeaker.

• Install this unit horizontally. Never use it on its

side or on a sloping surface, because it may cause
a malfunction.

• If you install this unit near a TV, radio, or VCR,

the picture and sound quality may be affected. If
this occurs, move this unit away from the TV,
radio, or VCR.

10. Moisture Condensation

Moisture condensation may damage this unit.

Read the following carefully:
Moisture may condense on the lens of the optical
pickup, one of the most important parts inside this unit.
• Moisture condensation can occur in the following

situations:
– The unit is moved from a cold place to a warm

place.

– A heater is turned on, or cold air from an air

conditioner is hitting the unit.

– In the summer, when this unit is moved from

an air conditioned room to a hot and humid
place.

– The unit is used in a humid place.

• Do not use this unit when there’s the possibility of

moisture condensation occurring. Doing so may
damage your discs and certain parts inside this
unit.

If condensation does occur, unplug the power cord
and leave the unit for two to three hours in the room
temperature.

This unit contains a semiconductor laser system and is
classified as a “CLASS 1 LASER PRODUCT”. So, to
use this model properly, read this Instruction Manual
carefully. In case of any trouble, please contact the
store where you purchased the unit.
To prevent being exposed to the laser beam, do not try
to open the enclosure.

CAUTION:

CLASS 1M VISIBLE AND INVISIBLE LASER
RADIATION WHEN OPEN. DO NOT VIEW
DIRECTLY WITH OPTICAL INSTRUMENTS.

Ventilation hole
Do not put anything on the
ventiation hole.