8
Installing the remote controller batteries
1. Remove the battery compartment cover by pressing
and sliding it away from the remote controller unit.
2. Insert two AA (R6- or UM-3)-size batteries into the
battery compartment. Carefully follow the polarity
diagram (positive (+) and negative (–) symbols) inside
the battery compartment.
3. After batteries are installed and seated correctly,
replace the compartment cover.
Notes:
• Do not mix new batteries with old batteries or different
kinds of batteries.
• To avoid corrosion, remove the batteries if the remote
controller is not to be used for a long time.
• Remove dead batteries immediately to avoid damage
from corrosion. If the remote controller doesn’t operate
smoothly, replace both the batteries at the same time.
• The life of the batteries supplied is about six months but
this will vary depending on usage.
Using the remote controller
Point the remote controller toward the remote control
sensor.
Notes:
• Place the unit away from strong light such as direct
sunlight or inverted fluorescent light which can prevent
proper operation of the remote controller.
• Using another remote controller of the same type in the
same room or using the unit near equipment which uses
infrared rays may cause operational interference.
• Do not put any object such as a book on the remote
controller. The buttons of the remote controller may be
pressed by mistake and drain the batteries.
• Make sure the audio rack doors do not have colored
glass. Placing the unit behind such doors may prevent
proper remote controller operation.
• If there is any obstacle between the remote controller and
the remote control sensor, the remote controller will not
operate.
Preparing the Remote Controller
DV-C501
STANDBY indicator
Remote control sensor
approx. 5 m
(16 feet)
3
2
1
30
30
