Onkyo DV-SP406 Instruction Manual Download

Page: 22 / 40

Adjust the settings

—Continued

If you selected 16:9, you’ll need to define how you
would like widescreen programs and films to be dis-
played on your TV screen.

[16:9 Widescreen]:

Choose this option if you have a widescreen TV
(16:9 aspect ratio). Depends on TV, the picture
appears stretched when watching programs in 4:3
format.

[16:9 Compressed]:

Choose this option if you
have a widescreen TV
(16:9 aspect ratio) and
the picture appears
stretched when watching programs in 4:3 format.
This option will correct the issue.

If you select 16:9, you must also select one of the fol-
lowing settings.

TV Output Select (European model only)

With this setting, you can choose the video output you
want to use to output component video. Before changing
this setting, refer to your TV’s manual to see if its
SCART input supports RGB.

RGB: RGB component video is output by the SCART
AV CONNECTOR.

YPbPr: YPbPr component video is output by the COM-
PONENT VIDEO OUT.

Note:

• When YPbPr is selected, composite video is output by

the SCART AV CONNECTOR.

Adjust the audio settings

Dolby Digital / DTS / MPEG –

Selects the type of dig-

ital audio signal when using the DIGITAL AUDIO
OUTPUT jack.

[Bitstream]:

Select this when you connect this unit’s DIGITAL
AUDIO OUTPUT jack to an amplifier with a
built-in Dolby Digital, DTS or MPEG decoder.

[PCM]

(for Dolby Digital / MPEG)

Select this when you connect this unit’s DIGITAL
AUDIO OUTPUT jack to an amplifier without a
built-in Dolby Digital or MPEG decoder.

[Off]

(for DTS)

Select this when you connect this unit’s DIGITAL
AUDIO OUTPUT jack to an amplifier without a
built-in DTS decoder.

Sample Freq. (Frequency) –

Selects the sampling fre-

quency of the audio signal.

[48 KHz]:

The audio signals are always converted

to 48 kHz.

[96 KHz]:

The audio signals are output in their

original format.

DRC (Dynamic Range Control) –

Make the sound

clear when the volume is turned down (Dolby Digital
only). Set to [On] for this effect.

Note:

• Settings changed while the unit is On are saved to

memory when the unit is set to Standby. If the unit’s
power cord is unplugged while the unit is still On, any
changed settings will not be saved. Be aware of this
when the unit is connected to a switched AC outlet on
another component.

Adjust the lock settings

You must set the [Area Code] option to use the lock
options. Select [Area Code] option then press [

] . Enter

a 4-digit password then press

ENTER

. Enter it again

then press

ENTER

to verify. If you make a mistake while

entering number, press

CLEAR

then correct it.

If you forget your password you can reset it. Display
setup menu then input the 6-digit number “210499”. The
“P CLr” appear in the display window and the password
is deleted.

Rating –

Select a rating level. The lower the level, the

stricter the rating. Select [Unlock] to deactivate the
rating.

Password –

Sets or changes the password for lock set-

tings.

[New]:

Enter a new 4-digits password using the
numerical buttons then press

ENTER

Enter the password again to confirm.

[Change]:

Enter the new password twice after