37
En
When you connect an
u
-capable Onkyo component, you
must configure the input display so that
u
can work
properly.
This setting can be done only from the front panel.
You can temporarily mute the output of the AV receiver.
This section explains how to record the selected input
source to a component with recording capability, and how
to record audio and video from different sources.
AV Recording
Audio sources can be recorded to a recorder (e.g., cassette
tape deck, CDR, MD recorder). Video sources can be
recorded to a video recorder (e.g., VCR, DVD recorder).
Changing the Input Display
1
Press
TV/CD
,
GAME
or
VCR/DVR
.
“
TV/CD
”, “
GAME
” or “
VCR/DVR
” appears on the
display.
2
Press and hold down the same button (about
3 seconds) to change the input display.
Repeat this step to select the desired input display.
■
TV/CD:
■
GAME:
■
VCR/DVR:
Note
•
DOCK
cannot be selected for multiple input selectors at the
same time.
• Enter the appropriate remote control code before using the
remote controller for the first time (
TV/CD
→
DOCK
→
→
TAPE
GAME
↔
DOCK
VCR/DVR
↔
DOCK
Muting the AV Receiver
1
Press
RECEIVER
followed by
MUTING
.
The output is muted and the
MUTING
indicator
flashes on the display.
Tip
• To unmute, press
MUTING
again or adjust the volume.
• Muting is automatically cancelled when the AV receiver is
set to Standby.
Using Headphones
1
Connect a pair of stereo headphones with a
standard plug (6.3 mm) to the
PHONES
jack.
Note
• Always turn down the volume before connecting your
headphones.
• While the headphones plug is inserted in the
PHONES
jack, the speakers are turned off.
• When you connect a pair of headphones, the listening mode
is set to Stereo, unless it’s already set to Stereo, Mono,
Direct, or Pure Audio.
• If you connect an iPod or iPhone to the
USB
port on this
device, no sound will be output from the headphones jack.
Recording
1
Use the input selector buttons to select the source
that you want to record.
You can watch the source while recording. The AV
receiver’s
MASTER VOLUME
control has no effect
on recording.
2
On your recorder, start recording.
3
On the source component, start playback.
If you select another input source during recording,
that input source will be recorded.
Summary of Contents for HT-R648
Page 75: ...75 En Memo...
