20
Troubleshooting
If you have any trouble using the T-4355, look for a solution here. If you can’t resolve the issue yourself, contact your
Onkyo dealer.
Can’t turn on the T-4355.
• Make sure that the power cord is properly plugged into the wall outlet (page 14).
• Unplug the power cord from the wall outlet, wait five seconds or more, then plug it in again.
There’s no sound.
• The T-4355 is not connected properly. Check all connections and correct as necessary.
• The wrong input source is selected on your amplifier. Check your amplifier’s input source setting. Refer to your
amplifier’s manual.
• Make sure the amplifier’s volume control is not set to minimum.
Reception is noisy, stereo FM reception suffers from hiss, the Auto Preset function doesn’t preset all
stations, or the ST indicator doesn’t light up when tuned to a stereo FM station.
• Check the antenna connections.
• Change the position of the antenna.
• Move the T-4355 away from a nearby TV or computer.
• Move power cords and speaker cables as far away as possible from the tuner’s antenna.
• Cars or airplanes can cause noisy interference.
• The radio signal will be weakened if it has to pass through a concrete wall before reaching the antenna.
• Try setting FM mode to mono.
• When listening to an AM station, noise may be heard when you operate the remote controller.
• If none of the above improves the reception, install an outdoor antenna.
Settings such as radio presets were deleted.
• Backup data can be stored incorrectly or destructed, and lead to a malfunction if either of the following operations is
performed:
- turning off the power immediately after an operation.
- repeating the fast power on/off switchings.
• When a malfunction occurred due to those operations, initialize T-4355 to its factory defaults (see below), then set
radio presets or other settings again.
The A-9355/A-9155’s remote controller doesn’t work.
• Point the remote controller at the A-9355/A-9155’s remote sensor (page 9).
• To use
, you must make an
connection and an audio connection between the A-9355/A-9155 and T-4355
(page 11).
Power
Audio
Radio
Remote Controller
The T-4355 contains a microcomputer for signal processing and control functions. In very rare
situations, severe interference, noise from an external source, or static electricity may cause it to
lockup. In the unlikely event that this should happen, unplug the power cord, wait at least five
seconds, and then plug it again.
To reset the T-4355 to its factory defaults, turn it on and, while holding down the [FM MODE]
button, press the [DISPLAY] button. “CLEAR” will appear on the display.
Summary of Contents for T-4355
Page 22: ...22 Memo ...
Page 23: ...23 Memo ...
