JL6803A
JL6804A
P6011A
P931
JL6952
A
JL6
9
51A
B
P6073A
JL6805A
P6301
JL6402A
P
6841
L
R
C
LS
RS
P997A
P6906
P6072A
P6840
JL6953A
SB
P6931A
P6000A
P6001A
P6002A
P6003A
P6004A
P6005A
P955A
ID-
ID+
R6040
P6080
ID-
ID+
R6041
P6081
ID-
ID+
R6042
P6082
ID-
ID+
R6043
P6083
ID-
ID+
R6044
P6084
ID-
ID+
R6045
P6085
TX-SR600/E
ADJUSTMENT AND CONFIRMATION PROCEDURES 1
Idling current adjustment
Before Idling adjustment, turn the trimming resistors R6040 to R6045 to counter clockwise.
Connect the DC voltmeter to sockets P6080 to P6085.
After turn POWER to ON, adjust the trimming resistors R6040, R6041 and R6042 so that the reading of
voltmeter becomes 2.5 mV. (Front and center channels)
Adjust the trimming resistors R6043, R6044 and R6045 so that the reading of
After adjustment, attach the top cover.
voltmeter becomes 1.5 mV. (Surround and surround back channels)
Confirm the voltage of points above after about five minutes.
Front and center channels
When less than 10.0 mV, readjust the resistors above so that the voltage becomes 10.0 mV.
When 10.0 mV to 12.0 mV, you are not necessary to adjust.
When more than 12.0 mV, readjust the resistors above so that the voltage becomes 12.0 mV.
Surround and surround back channels
When less than 7.0 mV, readjust the resistors above so that the voltage becomes 7.0 mV.
When 7.0 mV to 9.0 mV, you are not necessary to adjust.
When more than 9.0 mV, readjust the resistors above so that the voltage becomes 9.0 mV.
Note: No load and No signal
Confirmation of protection circuit
1. Confirmation of operation of speaker relay
Confirm that the speaker relays turn ON approximate. 5 seconds after the power switch is turned ON.
Confirm that the speaker relays turn OFF immediately after the power switch is turned OFF.
2. Confirmation of DC detection circuit
Press and hold down CD button, then press STANDBY/ON and DISPLAY buttons to set the unit to
"Test-1" mode.
After "Test-1" on the FL tube light on, press VIDEO 1 button to set the unit to "Test-1-00".
Apply DC 1.5 to 3V to DVD INPUT terminal with no load.
Confirm that the speaker relay turns OFF.
Apply DC -1.5 to -3V to DVD INPUT terminal with no load.
Confirm that the speaker relay turns OFF.
Caution: Don't apply DC voltage more than 1 sec..