Safety information
• The UPS system carries life-threatening voltages. All repair and maintenance work must be carried out by
customer service personnel.
• The UPS system has its own energy source (batteries). The output of the UPS system can be live even when
the UPS system is not connected to a source of alternating current.
• In order to reduce the risk of fire or electric shock, the UPS system may only be installed in buildings with
controlled temperature and air humidity in which there are no conductive contaminants. The ambient
temperature must not exceed 40°C. The UPS system must not be operated near water or in extremely high
air humidity (>90%).
• Before transporting the UPS system, make sure that it is disconnected from the power supply and switched
off and that the batteries are deactivated.
• Batteries can pose a risk of electric shock or catch fire as a result of high short circuit current. Please take
the necessary precautionary measures. Maintenance must be carried out by qualified personnel who are
trained in handling batteries and have good knowledge of the necessary precautionary measures. Keep
unauthorised personnel away from batteries.
• Batteries must be disposed of properly. Local regulations must be taken into consideration.
• Batteries must not be burnt. There is risk of explosion.
Table 1: Scope of delivery
XANTO
6000 / 10000
Battery pack
for XANTO
6000 – 10000
XANTO
10000 3/1
XANTO
20000 3/1
Battery pack
for XANTO
10000 3/1 –
20000 3/1
UPS
1
1
1
Battery pack
1
1
19"mounting bracket (left and right)
2
2
Feet for tower mounting (sets)
2
Extension for feet for tower fitting
2
USB interface cable
1
1
1
1
Parallel cable
1
1
1
1
Synchronisation cable (share current)
1
1
1
1
Battery cable
1
1
1
Quick start guide
1
1
1
1
1
DataWatch software*
1
1
1
Manual*
1
1
1
Safety information and quick start guide UPS XANTO
•
Page 9
