W A R T U N G
57 / 216
XS10000_manual_ger_eng_it_V1.1.2.doc
R. Kistler
1. Entfernen Sie die Frontblende von der USV-Anlage / dem Bat-
teriepaket.
HINWEIS
Das LCD Anzeige- und Bedienfeld ist durch ein Flachband-
kabel mit der USV-Anlage verbunden. Ziehen Sie nicht an
dem Kabel und trennen Sie die Verbindung nicht.
2. Trennen Sie die interne Batterie-Steckverbindung bzw. beim
Batteriepaket der XANTO S 10000 die externe Batterie-
Steckverbindung an der Rückseite.
3. Entfernen Sie die Batterieabdeckung.
4. Ziehen Sie den Batterieeinschub vorsichtig am Griff heraus.
HINWEIS
Überprüfen Sie, ob die Ersatzbatterien dieselben Spezifikati-
onen aufweisen wie die Altbatterien.
5. Tauschen Sie die Batterien im Batterieeinschub aus. Lesen
Sie den Abschnitt
„
Entsorgen der Altbatterien oder der USV-
Anlage
“ für eine sachgemäße Entsorgung.
6. Schieben Sie den Batterieeinschub mit den neuen Batterien in
das Gehäuse. Es muss dabei Druck ausgeübt werden.
7. Setzen Sie die Batterieabdeckung wieder ein.
ACHTUNG
Ein kleiner Lichtbogen kann auftreten, wenn die Batterien
angeschlossen werden. Das ist normal und kann nicht zur
Gefährdung von Personen führen. Führen Sie die Steckver-
bindung schnell und kräftig zusammen.
8. Die interne Batterie-Steckverbindung bzw. die externe Batte-
rieverbindung (Batteriepaket XANTO S 10000) muss wieder
angeschlossen werden.
9. Setzen Sie die Frontblende der USV-Anlage / dem Batteriepa-
ket wieder ein.
10. Fahren Sie mit dem Abschnitt
„
Testen der neuen Batterien
“
fort.
Summary of Contents for XANTO S 10000
