Quick start guide
PLEASE NOTE
Make sure that the overall rated performance of the load connected does not exceed the capacity of the
UPS system. The power consumption of inductive loads can be very high, please take this into considera-
tion when specifying your UPS system.
Laser Printers are not allowed to be connected!
1. Unpack UPS, check scope of delivery
2. Plug the mains connection cable (not included) of the load into a wall outlet socket 230V
230V ~
3. Switching on the UPS system
Push the
switch on the UPS system until you hear a short beep and the status LED
glow.
The UPS system is working in normal mode.
4. Connecting load
To connect the load to the UPS system, use the cold device extension cables provided. The load is now
powered by the UPS and protected against spikes and power failures.
Safety information and quick start guide UPS YUNTO
•
Pagina 9
