ONLINE USV-Systeme AG – Luise-Ullrich-Straße 8 – 82031 Grünwald / Germany - www.online-usv.de
ONLINE USV-Systems S.r.l. - Via Ferruccio Gilera 110 - I-20862 Arcore (MB) - www.online-ups.it
ONLINE USV-Systeme AG – c/o POTESTA AG - Hertistrasse 29 - 8304 Wallisellen (Zürich) - www.online-usv.ch
\X6000-20000_quickstart-saftety_ger-engl-it_final_20170309.docx
4. Connecting load
Attention: The XANTO 10000 3/1 and 20000 3/1 UPS systems have two groups of output sockets.
Critical loads should not be connected to the programmable output sockets.
5. Connecting battery pack
The XANTO 6000, 10000 and 20000 3/1 UPS systems have no internal battery. To operate them, at
least one battery pack is required. To install one or more battery packs, connect their “VDC Output”
to the “VDC Input” of the upstream battery pack. The battery pack connected directly to the UPS
system is connected to the “VDC Input” on the UPS system or the terminal block on the XANTO
20000 3/1. Switch on the battery fuse on the back of the battery pack.
Enter the number of battery packs used in menu no. 7 (see manual Chapter 4.4).
6. Supply the UPS system with utility power
Plug the mains connection cable of the load into a wall outlet socket.
Switch on the input switch on the back of the UPS system. The display
on the UPS system shows “Sb”,
7. Switching on the UPS system
Hold the “ON / / ” button on the UPS system down until you hear a
short beep. The UPS system carries out a self-test, after which “OK” ap-
pears on the display and continues in normal mode.
8. If an additional emergency stop switch has been installed, the emergency stop function needs to be
tested.
9. Switch the load on one by one.
The comprehensive user manual is available to download free at
