ENANCER Electrónica Lda
Página 2 de 3
Rua Max Grundig 9
4705-820 Braga Portugal info@only-smartbuildings.com
Tel: +351 253 221 484 www.only-smartbuildings.com
Functional Description
Input function programming
1.
Press the PROG key for 2 seconds. Release the key.
The green PROG led turns on, as well as leds 1,2,3 and 4.
2.
Select the desired input to modify the function using keys 1 to 4.
The green led flashes the number of times according to the following table:
1 – Toggle
2 – On
3 – Off
4 – Time
5 – Delay
6 - Scenario
3.
Press PROG repeatedly until the desired function is selected.
4.
Now press the [1..4] key to confirm your choice. If the command chosen is TIME or DELAY, the time selection
mode is selected, otherwise the choice is confirmed and the module exits programming.
5.
If the command chosen was TIME or DELAY, the LED will flash the number of times corresponding to the
selected time:
1 = 1 second
2 = 1 minute
3 = 5 minutes
4 = 10 minutes
5 = 15 minutes
6 = 20 minutes
7 = value already stored in memory
6.
Now select the time by pressing PROG repeatedly until the green LED flashes the number of times corresponding
to the desired time.
7.
Finally press the [1..4] key to confirm your choice.
Programming the contact type of the inputs:
The module inputs accept 3 different types of contacts: Push button, normally closed detector and normally
open detector.
To change the contact type, proceed as follows:
1.
Press the PROG key for 5 seconds until all the LEDs flash briefly. Release the key. The green PROG led
turns on, as well as leds 1, 2, 3 and 4.