11
2. Press and release the device button
(TV, DVD, SAT, AUX) which is
programmed to control the Master
Volume Feature.
3. Press and release the
MUTE
button.
4. Press and release the VOL -
button
. The red indicator light
will blink twice and go off.
To make sure the Master Volume
Feature is disabled, put the remote in
TV mode if you programmed the audio
receiver to be the Master Volume
Device. Point the remote at the TV and
press a volume button. If the volume
changes on the TV, the feature is
disabled. If the volume on the audio
receiver changes, and not the TV, you
will have to repeat the steps above
and test again.
Reset to Factory Settings
1. Press and hold the SETUP button
until the red indicator stays on
(approximately 4 seconds) and then
release the button.
2. Press and release the OK button.
3. Press and release the number #0
button. The red indicator light will
flash twice.
Master Volume Feature, cont.
