1-800-LOGGERS (564-4377) • 508-759-9500
www.onsetcomp.com • loggerhelp@onsetcomp.com
© 2009–2013 Onset Computer Corporation. All rights reserved. Onset, HOBO, and HOBOware are
trademarks or registered trademarks of Onset Computer Corporation. All other trademarks are the
property of their respective companies.
12990-B MAN-CABLE-U23-002
3.
Plug the mini-USB connector from the cable into the jack on
the bottom of the board.
4.
Secure the cable to the board using the cable tie (included).
Feed the tie through the two holes near the end of the
board, with the cable tie’s ‘buckle’ on the battery side of the
board. Ensure that cable tie is tight and then trim the end.
5.
Slide the board into the case. Align the sides of the board
with the grooves on the side of the case. Push the board into
the case until the outermost edges of the board are flush
with the beginning of the rails.
Gently
pull the cable where it
exits the grommet as you insert the board.
IMPORTANT
: You can press on the end of the board to help
guide it into the case, but do not press on the LED and
photodiode leads or they may be damaged.
6.
Re-insert the 3 desiccant packs.
7.
Re-install end cap. Make sure the O-ring on the end cap is
still in place. It should not be pinched, twisted, or trapping
dirt or lint, which could interfere with the end cap. Line up
the two small bumps on the end cap with the two notches at
the end of the case and then push end cap in and lock into
place by turning clockwise just slightly until bumps prevent
further rotation.
8.
Tighten dome nut.
