HOBO U30 Station (NRC) User’s Guide
33
3.
Press Channel into Case
a)
Close the channel, making sure the cables, wires, and any plugs
remain in their grooves.
b)
Press the channel into the opening.
To reduce the amount of excess cable in the case (especially when
several Smart Sensors are connected),
gently
pull the cables toward
you as you press the channel into place.
Press the channel in until it is flush with the outside of the case.
(When fully seated, the channel will project slightly into the inside
of the case.)
Channel pressed into case
4.
If you are using the Smart Sensor expander board, then repeat these
steps with the second cable channel. Use the larger plug for the leftmost
hole if necessary.
34
HOBO U30 Station (NRC) User’s Guide
5.
Secure Channel Guide
Screw the retaining bars on to the case to secure the channel(s). The bars
should be flat against the case.
Finger-tighten only! Do not use a screwdriver to tighten the thumb
screws. You may need a screwdriver to loosen them after time in the
field.
Retaining bars installed
