DX26/DX32 OPERATOR MANUAL
9
Rev 4 –11/4/2021
1.
Stop and place the machine on the level ground
and take out the key. Lift up
the recovery tank to expose the
battery cabin.
2.
Carefully install the four 6V batteries
in the battery cabin and connect the battery cable
according to the
following figure:
Note:
Gently place each battery into the battery cabin
to avoid damage to the battery and the machine.
Hint:
Paint a thin layer of metal-free lubricating oil or protective spray on the connected wiring to
avoid battery corrosion.
3.
Before connecting the battery, please first ensure whether the electrodes and electric terminals
are clean. Use electrode cleaning fluid and wire brush as required.
4.
After the battery is installed, please check the scale of the battery power meter. Charge the battery
as required.
Installation and Connection of Squeegee Component
1.
Stop and place the machine on the level ground,
and take out the key.
2.
Lower the lifting rod of the squeegee
to the lower position.
3.
Install the squeegee to the squeegee installation
bracket as shown in the figure. Ensure to fully
place the fastening knob into the jack and then
tighten the knob.
