Onyx RX32, Operator'S Manual

5

SAFETY PRECAUTIONS

The ONYX RX-32 Ride-On scrubber is designed to scrub hard surfaces (concrete, asphalt, stone, syn-

thetic, etc) in an indoor environment. Typical applications include hotels, schools, hospitals, factories, 

shops, offices, and rental businesses. Do not use this machine on carpeted surfaces. Use only recom

-

mended pads and commercially available floor cleaners intended for machine application. Do not use 

this machine on soil, grass, artificial turf, or carpeted surfaces. This machine is intended for indoor use 

only.

This machine is not intended for use on public roadways. Do not use this machine other than described 

in this

Operator Manual.

This “WARNING” alert symbol and the “FOR SAFETY” alert symbol are used

throughout this manual as indicated in their description:

WARNING: To warn of hazards or unsafe practices which could result

in severe personal injury or death.

FOR SAFETY:

 To identify actions which must be followed for safe operation of equipment.

All operators must read, understand and observe the following safety precautions.

The following safety precautions signal potentially dangerous conditions to the operator or equipment. 

If the following warnings are not observed, it may cause personal injury, electric shock, fire or explosion.

WARNING: Fire or Explosion Hazard:

• 

Do not use flammable liquid; do not operate the machine close to or in the place where 

there is flammable liquids, vapors or combustible dust.

• 

This machine is not equipped with explosion-proof motor. If this machine is used in the 

place where there is flammable vapors, liquids or combustible dust, electric motor may 

generate spark during the start and operation, which may cause flash fire or explosion.

• 

Do not pick up flammable materials or reactive metals.

• 

The battery releases hydrogen. Please keep away from sparks or open flame. The battery 

cabin must be kept open when charging.

WARNING: Electric Shock Hazard

• 

Please first disconnect the battery cables before performing any maintenance on the 

machine.

• 

If the charger supply cord is damaged or broken, it must be replaced by the manufacturer 

or its service agent or a similarly qualified person in order to avoid a hazard.