Opale -Paramodels.com
Opale Aero System SARL - 23 rue de la Motte
62250 MARQUISE - France
contact@opale-paramodels.com +33(0)981 144 387
BA
CKP
ACK L2
BA
CKP
ACK L2
Assembly of the servo holder kit
The servomotor holder kit is an accessory that makes
it possible to dispense with the use of a pilot to con-
trol the wing.
Once attached to the chassis, it can accommodate a
total of 4x 40x20mm servomotors size, for the use of
the arms but also the accelerator.
First of all, mount a 40x20mm servomotor on the
surface of the board, with a minimum torque of 30kg.
cm, using 4x CHC M3-8 screws and brake nuts.
You can, optionally, attach a servomotor for the use
of the accelerator with also 4x CHC M3-8 screws.
However, for the accelerator, this servomotor must be
placed from the inside in order to work in a different
and parallel plane of the servomotor of the arms. This
type of assembly avoids a collision of arms in flight.
Then use two CHC M3-25 and M3-16 screws to secure
the plate to the chassis.
Perform the same operation by symmetry on the
other side.
Then install the arm on the servomotor orn with
2x 2x8 philips screws. It must have an amplitude of
movement of + 45 ° to -45 ° relative to the horizontal,
in order to guarantee an optimal control.
18
