www.opcomfarm.com
For more information, please visit
Quick Guide Manual
Ver.: 190601
Free Stackable Farming
F. Maintenance
G. Troubleshooting
Checkpoints / Solution
Make sure all power cables are connected.
Make sure Power button is ON.
Make sure LED status is ON
If LED Status is on HI or LOW mode, the lamp has off time, during 24-hour cycle.
Pump may give off a buzzing sound in the beginning due to air inside the pump. After a minute with
water running through the pump, this sould be reduced.
Control Box is designed with Auto, HI and LOW modes, which turn the lamps and the pump on and off at certain
in tervals. It simulates an outdoor daily cycle to offer the best growing condition
Rotate the ring at the front end of the pump clockwise or counterclockwise to get the most suitable water flow
Issue
Lamps not
lighting up
Pump has a
buzzing sound
The lamp/ pump
stop after hours
F1. Add Water
1. Measure the pH/EC value every week and add water to achieve the vlaue balance
F2. Change Water
1. After a cycle of planting, you should change water or clean the unit(Fig1)
.
3. After drain the water, please wipe off the water tank.
1. Growing Sponge D65
2. 50W Water Auto Heater
3. Black Cloth Cover
4. OPCOM Link Box
E. Optional Accessories
1. Everytime you use the EC/pH Meter, please wash electrode by regular water and keep it dry.
2. Cover the electrode protective cap when not in use.
3. Turn off the meter when not in use for an extended amount of time.
F3. EC / pH Meter Use and Calibration
2. When change water, you can use water outlet on the left side to leak the water. Plug
out plastic lid(Fig2), plug in water pipe(Fig3), then plug out water tank inside stopper.(Fig4)
H. Q&A
Answer
Question
For better growing and avoid insect and diseases, we offer high density insect net. (even
small insects can not go through ). We suggest you can put on the insect net during the
whole growing stage.
When should I use the insect net?
F1708048
F17103001
F1709049
P17092805
Intertek
US
C
CM
LTSTED
4010499
(Fig1)
(Fig3)
(Fig4)
(Fig2)
