CONTENTS
INSTALLATION
1.
Apply template sticker to desired
camera location.
2.
Drill anchor holes using included
mounting template.
3.
Remove mounting template.
4.
Insert anchors.
5.
Mount camera.
6.
Connect network cable with
included waterproof cable
connector.
7.
Adjust camera view.
NOTE:
If the camera will be exposed
to inclement weather, OpenEye
recommends sealing around the
camera base, or connection to
mounting surface with outdoor
waterproof caulking.
NOTE:
To change this IP address please refer
to your Apex recorder manual.
ASSIGNING AN
IP ADDRESS
OpenEye IP cameras are set to DHCP
by default. If a DHCP server is not
detected after 4 minutes, the camera
will default to IP address 192.168.51.2.
If you are not using a DHCP server,
NCM will allow you to batch confi gure
a static IP address.
The IP address for the camera network
on your Apex recorder is 192.168.51.1.
OE-C1016T2 Turret
Camera
Waterproof Cable
Connector
Self-Tapping
Screws &
Plastic Anchors
Hex Tool
Quick Start
Guide
Mounting Template
Selecting multiple cameras and enter-
ing IP address 192.168.51.2 will set
an IP address on all selected cameras,
starting at 192.168.51.2 and increase
per camera.
1.
Open Network Camera Manager.
2.
Select applicable camera(s).
3.
Input starting IP address, Subnet
Mask, Gateway, DNS.
4.
Apply changes.
5.
Wait 60 seconds before refreshing
NCM.
CONNECTING TO THE
IP CAMERA
To access the camera setup menu,
you need to open Network Camera
Manager (NCM) utility. NCM is pre-
installed on all OpenEye Recorders,
and is also available for download on
the OpenEye website for installation on
your personal computer or laptop.
1.
Open Network Camera Manager.
2.
Locate your camera on the
Network Camera Manager list.
3.
To open the web browser, select
the camera and click LOAD.
NOTE:
OpenEye IP cameras ship
without a default password.
DEFAULT USERNAME
AND PASSWORD
The admin user password can be set
using the following methods:
1.
OpenEye recorders running Apex
2.1 or newer will automatically set
a new unique password if:
•
Connected to an M-Series
recorder with a built in PoE
switch.
•
Connected to a network
switch through the
camera network port
and selected then added in
setup, if a new password has
not already been set.
NOTE:
The NCM software manual can be
found at
https://www.openeye.net/
ncm-manual
2.
Connect to the camera directly
through a Web Browser and follow
the onscreen prompts.
3.
Use the Network Camera Manager
(NCM) Utility.
Username:
admin
Set the Default Camera Password
Use the QR code or link for instructions on
defi ning a unique camera password:
https://www.openeye.net/support/faqs/
default-camera-password
PRODUCT FEATURES
Camera
Maximum Resolution
1920x1080
Frame Rate at
Maximum Resolution
30FPS @ 2MP H.264/H.265
Total Streams
Dual Streaming
ONVIF
Profi le S / G / T Compliant
Day/Night
True Day / Night
Wide Dynamic Range
True WDR
Environmental and Power
Power
Consumption
5W Max
Input Voltage
12vDC / PoE
Pan / Tilt / Rotate
Pan: 0° ~ 360°
Tilt: 0° ~ 80°
Rotate: 0° ~ 360°
IP Rating
IP67
