ACM5504-‐5-‐GS-‐I Quick Start (520071-‐Rev 1.0)
Page
1
ACM5504-‐5-‐GS-‐I
Quick Start Guide
Thank you for purchasing the ACM5504-5-GS-I management gateway. This Quick Start
walks you through installation, configuration & local operation. More details are available
in the
User Manual
, which can be downloaded from:
http://opengear.com/documentation
Step 1 Check kit contents
ACM5504-5-GS-I appliance. E
xternal rack and DIN
rail m
ount tabs. G
reen terminal block and
3G
antenna. UTP cables. Straight (319014) & crossover
(319015) DB9F-RJ45s. Straight (319016) DB9M-
RJ45. Quick Start. 12VDC power pack.
Step 2 Connect the hardware
Ø
Attach rubber feet to base and/or attach the desired mounting tab
Ø
Screw the 3G antenna on to the main
Cell (M)
connector, if you have purchased
a diversity or GPS antenna, screw it on to
Cell (A)
Ø
Connect the Ethernet
LAN
port to your network, connect your management LAN
devices to the
ETHERNET 1-4
ports
Ø
Connect your serial devices to the
SERIAL
1-4
ports, connect your USB devices
to the two
USB
ports
Ø
Plug in the green screw terminal block and attach external sensors and DIO
Note:
Refer to the
ACM5500-I Addendum
for details on RS422/485 and DIO.
Ø
Apply power, the appliance may be powered by connecting:
o
The included power pack to the
12VDC
barrel socket
o
An external 9 – 24V AC source to the
12VDC
barrel socket
o
An external +9 – 30V DC source to
DC PWR
and
GND
on the green
terminal block
o
The optional DC power converter input to +/- 36V – 72V DC, and output to
the 12vDC barrel socket
o
The optional C13/C14 power adapter to the
12VDC
barrel socket
Note:
When the PWR status LED is lit steadily and the H/B (heartbeat) is flashing,
the appliance is ready for activation.
