ACM5504-5-GV-I Quick Start (520040-Rev 1.3)
Page 2
Enter
https://192.168.0.1
into the address bar
Note:
The
LAN
connected computer must have an IP address in the same network range
(192.168.0.xxx) as the ACM5504-5-GV-I. If this is not convenient, you can use
the ARP Ping command to set the IP address. Refer to the User Manual or online
FAQ for details. The ACM5504-5-GV-I also has DHCP enabled by default, so it will
automatically accept any network IP address assigned by any DHCP server on
your network. It will then respond at both 192.168.0.1 and its DHCP address
o
Log in using the default system user name
root
and the password
default.
A
Welcome
screen listing the basic configuration steps is displayed
It is recommended that you set up a new Administrator user (in the
admin
group with
full access privileges) and login as this new user for all ongoing administration functions
(rather than continuing as
root
).
Select
System: Administration
. Enter and confirm a new
System Password
and click
Apply
To assign your ACM5504-5-GV-I a static IP address or to permanently enable
DHCP on the primary Ethernet network, select
System: IP
then
Network
Interface
and check
DHCP
or
Static
for
Configuration Method
. Leave the
Failover Interface
set to
None
Configure the RMM appliance connectivity:
Configure the serial port settings and enable the desired protocols and logging
levels via
Serial & Network: Serial Port
Attached USB devices are auto-configured so you can access
to USB console
ports, modems or
external USB flash (the ACM5504-5-GV-I also has an internal
4GB flash)
You may also enable SSH tunneled access through the ACM5504-5-GV-I to
locally networked devices (
hosts
) using
Serial & Network: Network Hosts
o
Configure user access to serial ports via
Serial & Network: Users & Groups
Step 4 Connect the cellular modem
Select the
Internal Cellular Modem
tab on the
System: Dial
menu.
The
ACM5504-GV-I supports both OTASP (
Over-the-Air Service Provisioning
where
modem specific parameters can be retrieved via a call to a special phone number)
and a manual process where the phone number and other parameters can be
entered manually.
o
For OTASP, enter *22899 as the number to be dialed (for Verizon)
