ACM5504-5-GV-I Quick Start (520040-Rev 1.3)
Page 3
o
For manual activation enter the
MSL
,
MDN
and
MSID
values. Verizon
have been known to use an
MSL
o
f 000000
and the phone number
assigned to the ACM5504-GV-I as both the
MDN
and
MSID
Click
Activate
. If no errors occur you will see a valid phone number being placed
in the
NAM Profile Account MDN
field (
Cellular
page on
Status: Statistics)
Enable the
Internal Cellular Modem
by entering the carriers phone number
(which defaults to
#777
)
You may also need to use alternate DNS servers from those provided by your carrier:
Enable
Override DNS
. Then check the
Override returned DNS Servers
box
and enter the IP of the DNS servers into the spaces provided.
Check
Apply
and a radio connection will be established with your cellular carrier.
Out-of-band access
is enabled, so the cellular modem connection is always ON.
Verify the
Connection Status
in the
Statistics - Failover& Out-of-Band
tab is
shown as
Connected
. You can also check your allocated
IP address
You can measure the received signal strength
RSSI
from the
Cellular
Statistics
page on the
Status: Statistics
screen. -99 dbm to –90 dbm = Weak
Coverage, -89 dbm to – 70 dbm = Medium, -69 dbm or greater = Strong
Note:
You can also see the connection status from the WWAN LED. OFF is shown when in
reset mode or not powered. When powered, it will go ON and while searching for
service it will flash off briefly every 5 seconds. Once a radio connection has been
established with your cellular carrier (ie, after an APN has been properly
configured) the WWAN LED will blink rapidly
Step 5 OoB access
To directly access the ACM5504-5-GV-I, it needs a public IP address and must not have
SSH access firewalled. Almost all carriers offer corporate mobile data service/plans with a
Public (static or dynamic) IP address. These plans often have a service fee attached.
If you have such a static Public IP address plan, you can now try accessing the
ACM5504-5-GV-I using the Public IP Address provided by the carrier. However, by
default, only HTTPS and SSH access is enabled on the OoB connection. So you
can browse to the ACM5504-5-G-I, but you cannot
ping
it
If you have a dynamic Public IP address plan, then a DDNS service will need to
be configured. Once this is done, you can then also try accessing the ACM5504-5-
GV-I using the allocated domain name
If your service by default assigns a dynamic Private IP address to your 3G device then
this IP address is not visible across the Internet.
With such a plan, the
Failover & Out-of-Band
tab on the
Status: Statistics
page, will show your carrier allocated a Private
IP Address
(i.e. in the range
10.0.x.x, 172.16.x.x or 192.168.x.x)
For an inbound OoB connection with such a plan, you will need to use Call Home
with a VCMS/CMS6110 or set up a VPN connection
In this default
out of band access mode
, the connection to the carrier cellular network
is always on - awaiting any incoming access to the ACM5504-5-GV-I or attached serial
consoles/network hosts.
