UC Series User Manual
72
OpenVox Communication Co. , LTD.
URL: www.openvox.cn
If there are less than 4 recognized headers then the remaining columns will be blank.
Add Trunks
Trunks used by this outbound route, the available trunks are on the left options bar and the
selected on the right.
Advanced
Route Type
Optional: Selecting Emergency will enforce the use of a device
Music On Hold
You can choose which music category to use. For example, choose a type appropriate for a
destination country which may have announcements in the appropriate language.
Time Group
If this route should only be available during certain times then Select a Time Group created
under Time Groups. The route will be ignored outside of times specified in that Time Group.
If left as default of Permanent Route then it will always be available.
Route Position
Where to insert this route or relocate it relative to the other routes.
Call Recording
Controls or overrides the call recording behavior for calls coming into this DID. Allow will
honor the normal downstream call recording settings. Record on Answer starts recording
when the call would otherwise be recorded ignoring any settings that say otherwise. Record
Immediately will start recording right away capturing ringing announcements, MoH, etc.
Never will disallow recording regardless of downstream settings.
PIN Set
Optional: Select a PIN set to use. If using this option, leave the Route Password field blank.
Optional
Destination on
Congestion
If all the trunks fail because of Asterisk ‘CONGESTION’ dial status you can optionally go to
a destination such as a unique recorded message or anywhere else. This destination will
NOT be engaged if the trunk is reporting busy, invalid numbers or anything else that would
imply the trunk was able to make an ‘intelligent’ choice about the number that was dialed.
The ‘Normal Congestion’ behavior is to play the ‘ALL Circuits Busy’ recording or other
options configured in the route Congestion Messages module when installed.
2.2.3.3 Blacklist
The Blacklist Module is used to add phone numbers to the blacklist or remove phone numbers from
the blacklist.
You can also choose to blacklist any blocked or unknown calls.
When a number is blacklisted, any calls that are received by the system with that number in the
Caller ID field will be routed to a disconnect recording.
Figure 2-2-14 Blacklist interface
