pic1 pic2
When the suction arm is not placed on the record, open the water suction
switch. The pointer of the barometer points to -0.02~-0.04. If the barometer is
less than 0.02, the sewage bottle may not be tightened.
（
pic1
）
When the suction arm is placed on the record to start working, the pointer of
the barometer points in the range of -0.05~-0.07. If the barometer is larger than
-0.07, the suction hole may be blocked. Lift the suction arm and then lower it to
solve.
（
pic2
）
Note: The air pressure will increase when the suction head reaches the
edge of the record. Adjusting the front and rear position of the weight of
the suction arm can finely adjust the water pressure.
2.
Check the water in the sewage bottle regularly. If it exceeds half a bottle,
pour it off and cut off the cleaning line. Install the bottle. Please gently align the
cover and tighten it counterclockwise.
unplug the power cable.
3. The sewage bottle needs to be squared and carefully rotated to the marked
position, otherwise it will leak.
4. There is a clean water drop when cleaning the disc, and a special plastic
tray can be purchased to prevent clean water from flowing into the surface of
the main unit.
Specifications
：
Use voltage: 220~230V 50Hz
Rated power: 300W
Dimension: 400x320x330mm
（
WxDxH
）
