Operation
63
FalconV User Manual - Standard Scanning - OPEX Corporation
Scanning items
After you have selected a job, you are ready to scan items. Before you do, here
are a few things to remember:
Removing items from an envelope
Items that are tri-folded tend to have the
top and bottom sections lifted up. Prior to
dropping any tri-folded items, flatten the
ends, allowing for a smoother feed.
As items are dropped onto the conveyor,
it’s important to drop them in such a way as to have the items fully justify to the
side rail prior to entering the feeder. The conveyor rollers are angled to assist
in justifying the items to the side rail as they are dropped. Drop the items far
enough back so that they will have time to straighten. If items are not fully
justified as they enter the feeder section, skew jams may occur. It should also
be noted that enough space gap should be allotted between items. At least ½
inch between items will provide for proper image capture.
Examples:
When dropping items, give enough time for items to justify. The
thick line indicates feeder entrance. The arrow indicates the paper path.
WRONG
- In these 4 examples, the items are dropped too close to the feeder to
be justified.
RIGHT
- items should be as aligned as possible as they enter the feeder.
Summary of Contents for FalconV
Page 5: ...5 FalconV User Manual Standard Scanning OPEX Corporation Performance Details statistics 119...
Page 6: ...6 FalconV User Manual Standard Scanning OPEX Corporation...
Page 82: ...82 Operation FalconV User Manual Standard Scanning OPEX Corporation Figure 24 Ending the job...
Page 110: ...110 Maintenance FalconV User Manual Standard Scanning OPEX Corporation...
