Pyrocam III
HR
User Guide
Document No. 50361-001
Rev E
7/18/2017
Page 12
Turn on/off BP correction, demonstrates the current impact of the mapped BP’s
The
Source Information
group shows how many more pixels you can mark as bad and how
many pixels have already been BP marked.
The
Save and Load
group allows you to save or load a Bad Pixel map file for use by the
Pyrocam.
The
Cursor
group sets the BeamGage Cursor mode to select a BP location using either a
Manual
or
Peak
detection mode. The X and Y values indicate the pixel coordinate of the
currently selected pixel location. The
Manual
mode is used to select dark, dim, or bright pixels
one at a time. The
Peak
mode is used to find pixels that indicate too bright.
Note:
Pixel coordinates are mapped from the lower left corner starting at location 0,0.
Add Pixel to List
Click to add the pixel at the current cursor location to the BP correction
List
.
Remove Pixel from List
Click to remove a pixel selected from the
Pixels
dropdown from the pixel correction
List
.
Write Pixel List
Click to write the current pixel
List
to the camera.
Read Pixel List
Click to read the current pixel
List
from the camera.
Clear Pixel List
Clears all marked pixels from the correction
List.
