3
6
7
5
4
4a
4a
4b
ø4
9
10
8
Glue the wooden strips from step 6 on top of 1a.
Glue the motor mount (2) centrical and flush with the rear edge on the
upper part of 1b.
Glue the intermediate piece (5) on the front part of 1a.
4a
4a
4b
ø8
1a
1b
1a
Cut the wooden strip (4) according to the instructions and clen the
saw cuts.
Cut the wooden strip (3) according to the instructions and clen the saw
cuts. Take the 45mm long piece and drill a 4mm big hole in it as shown.
Moreover drill a 5mm deep blind hole in it. Use the ø 8mm drill.
3b
Transfer the template for the intermediate piece (5) (page 9)on the
plywood (5) and saw it with the fretsaw. Clean the saw cuts with the
sandpaper and the file.
5
Instructions 101.141
LT-Racer with Propeller Drive
5
3a