3
12
13
Put the manufactured motor into the clamp.
Instructions 101.141
LT-Racer with Propeller Drive
12
14
14
13
19
11
Insert the switch (13) in the anticipated eyelet of ø 15mm.
15
Crosscut three cable pieces (2x 150mm, 1x 200mm) from the jumper
wire (18) and remove insulation on both sides. Attach one cable
(150mm) to the positive terminal of the motor (marked with point),
take it through the drill in the upper part and connect it to the
external switch port. Connect the second end with the middle switch
connector and connect the other end with a blade receptacle (19).
Connect the 200mm cable to the negative terminal of the motor, take
it through the drill and connect the end with a blade receptacle (19).
Solder the connections.
200mm
150mm
150mm
Fix the propeller blades (20) with the cylinder head screws (21) on the
propeller hub (22) as shown. Afterwards put the rotor on the motor
drive (11).
20
22
21
11
Put the spring steel clamp (12) centrical on the motor mount (2) as
shown and fix it with the chipboard screw (14).
