Instructions 101.141
LT-Racer with Propeller Drive
16
17
ø4
18
Install the front axle support (3a) with the cylinder head screw (15) and
one washer (17) as shown. Fix it with two nuts (16) and one washer
from above.
19
Glue the rear axle support (3b) flush with the rear edge on the bottom
side. Let the glue dry well.
21
10
Insert the metal axis (10) as shown and clip on spacers (7) on each
side. Then fix the impellers (6).
6
7
20
Transfer and mark the position oft he eye bolts (8) on the axle suppor-
ters according to the instructions. Screw the eye bolts in and look to it
that the eye bolts of each axle are exactly mirrored.
Glue the top on the intermediate piece (5) and the wooden strips (4a -
4c) as shown. Fix it with locking clamps until the glue is dry.
3a
15
17
16
3b
Now drill the intermediate piece and the base with a 4mm drill use
the drill in the upper part.
6
7
8
